Page 2 of 3 FirstFirst 123 LastLast
Results 11 to 20 of 26

Thread: feeding pause

  1. #11
    Join Date
    11.03.2011
    Posts
    107

  2. #12
    Join Date
    11.03.2011
    Posts
    107

  3. #13
    Join Date
    11.03.2011
    Posts
    107

  4. #14
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    and how are the pump-settings? especially the behaviour during feed pause?
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  5. #15
    Join Date
    11.03.2011
    Posts
    107

    Default

    Screenshot 22032012.jpg both groups are the same
    Attached Images Attached Images
    Last edited by scrub29; 22.03.2012 at 18:33.

  6. #16
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    enable "pump completely off during feed pause"
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  7. #17
    Join Date
    11.03.2011
    Posts
    107

    Default

    Hi I did enable it but it stays the same i will not go off or go from 50 to 75 % like i programmed it! it just goes on full speed on all pomps!!

  8. #18
    Join Date
    11.03.2011
    Posts
    107

    Default

    Matthias,

    Do you know what to do now?

    thx

  9. #19
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    so when you enable feed pause this happens:

    1.) ProfiLuxControl shows 0% flow for the pump in question
    2.) the 1-10V interface shows 0V
    3.) but the pumps do not react at all

    is this correct?
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  10. #20
    Join Date
    11.03.2011
    Posts
    107

    Default

    Yes that's correct

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •