Originally Posted by
Matthias
the contactless level sensor is designed to deal with a glass thickness up to 20mm
for this reason the sensitivity is adjustable (with the potentiometer on the rear)
just as mentioned in the manual: move the sensor up and down near the water level, if the sensor react too late or too early than adjust the pot. position
do this until the sensor triggers at the level you want
powerbar: set the function of the socket you want to use to "water 1" (or 2, 3...)
and use the correct operational mode for the sensor (e.g. ATO)
-> all this is explained in the ProfiLux manual
Bookmarks