Hello,
Why is it not possible to have this option in the logic part of this controller ?
if I take ph for example I only have increase , decrease , alarm
But forexample if I want to make a smart ATO , that adds fresh water if my sal probe is higer or eqaul to my sal
and I would add salt water if my sal is lower then my sal.
currently the profilux takes no decision if its on target and the alarm goes off after a while because my ato goes into alarm
offcourse to avoid to get the profilux confused you can not have more then 1 time 'x or equal' for the same sensor in the same logic.
Bookmarks