Hello,
I was trying to create a new alarm email.
But I can't seem to figure out what I'm doing wrong ( I compared it to my other loops for sensors but I missing it.)
running FW 5.10
according to this page in the web token doc
$$ALMS[n]$$
Current alarm state, n determines which alarm source should be displayed
Since it is unknown if and how many alarms are active the use of the indexed alarm-token makes only sense if used in a loop, see example below
(ProfiLux firmware 5.05e or higher required)
msg:
taken from last page of the token manual
Alarms
$$REPS[10][5]$$
<p>$$ALMS[x]$$</p>
$$REPE$$
and I just get :
Alarms
Whats wrong ?
Bookmarks