Alarm buzzer selectable from the User

[almost]

Now that the new leackage sensor came, I was thinking that I would like to have the buzzer ON only if the alarm on my profilux3ex is triggered by this sensor and not for instance from pH increase.
This way I could wake up if the skimmer goes nuts.

So if a user could set, in which alarms the buzzer should be ON and in which alarms the buzzer should be OFF, that would be great.

[almost]

Please!!!

I want to use the leackage sensor but I only want to wake up from the buzzer if there is a leakage and not because pH drops (or whatever).

Please!!

[Matthias]

if you don't want to get an alarm from pH or whatever why do you activate the alarm for these things at all?

[BigAl07]

Matthias is correct. Each item (temp, pH, etc) you can deselect the ALARM function in PLC.

PLC Software
Probes/sensor controls
pH/Temp (select the function you're wanting to turn ALARM off for)
right in the middle of the page you'll see

ALARM - Not enabled

[almost]

When I am out of home I like to get emails when pH drops etc.

When I am at home I prefer watching the Profilux View display, its aside the TV.

But at nights it will be better to have a buzzer only in critical matters.

I prefer to use one plug fron the Powerbar just to control a cheap buzzer by muself from loosing all alarm emails.

Although I think its a waste of plug for such a hi end controller.

[Antipodes]

When I am out of home I like to get emails when pH drops etc.

When I am at home I prefer watching the Profilux View display, its aside the TV.

But at nights it will be better to have a buzzer only in critical matters.

I prefer to use one plug fron the Powerbar just to control a cheap buzzer by muself from loosing all alarm emails.

Although I think its a waste of plug for such a hi end controller.

Hi,
I have almost the same configuration in that I do not want the buzzer during the day, particularly when I am doing auto water changes etc.
So I will only receive a email if the alarm activates (light will still go on front of controller)
So I set in the general page in the PLC, you can set buzzer on time. I set this for 2200 at night to 0700 in the morning. So I wake up if any thing major happens.