ok you've convinced me to make one final effort!
Ill report back in 5
nope!
its back in the box again!
thanks for your efforts though guys, going to try the netgear.
Actually went for the D link instead as i may want to hook up a network camera later down the line.
Will let you know how that goes but may not have it for a week!
The software finally downloaded and it worked! The gits gave me some defective software to install with the device!
Thanks for the advice Wirus!
Cancelled the D link for now and have the PLC hooked up via wlan but seems to keep scanning network for profilux all the time! any suggestions?
Don´t know your settings, but you have to set the PL3 to same IP as you have set for the VAP11G. Have in mind: It´s a transparent (means: invisible) bridge. If the IPs are different it can´t work.but seems to keep scanning network for profilux all the time! any suggestions?
The Lan IP Address on the profilux is the same as the vonet IP on my router.
Its like the vonet just keeps losing connection. Have looked on the website and there is a firmware update that says
resolved the instability that’s because XC instruction is not aligned.
Could that be the problem?
Hi zusammen,
da mein englisch nicht so toll ist und ich kein gleichnamiges Thema erstellen möchte, frag ich mal auf deutsch,
ich habe mir auch eine Home Base besorgt,
möchte damit eine Verbindung mit mein Pl2 erreichen.
nun schliesse ich mein usb zu rs232 und erreiche auch eine Verbindung damit.
im "Gerätemaneger" wird er auch erkannt, mit Fehlermeldung aber!
habe mittlerweile jeden Treiber installiert.
könnte mir vielleicht jemand einen tipp geben?
Also nochmal zur Verdeutlichung....
pl2 zu original mitgelieferten Kabel zu USB-rs232 Adapter.
diese an der Home Base angeschlossen.
Im Windows 7 wird es erkannt und Steht im Gerätemaneger unter:
Prolific USB to Serial Comm Port (COM4)
Gerätestatus aber:
Das Gerät kann nicht gestartet werden (Code 10)
Last edited by Giovag85; 17.12.2011 at 11:29.
Bookmarks