Can I use this for wireless programming and commincation to my profilux?
http://www.amazon.co.uk/Belkin-Serve...2779161&sr=8-1
Can I use this for wireless programming and commincation to my profilux?
http://www.amazon.co.uk/Belkin-Serve...2779161&sr=8-1
possible, it seems so, but we didn't test it
so I can't guarantee for compatibility
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Thanks
Definately worth a try, and will let you know if it works
shardyl why not opt to get one that others have tried and know it works? Myself and a few others are running this one and it was pretty simple to configure
http://www.amazon.co.uk/D-link-DAP-1...2835343&sr=1-1
Thanks Al!
I will certainly use this if the belkin doesn't work, Its just that I aready have the belkin working for the seneye and it has 4 usb ports so fingers crossed it works!
It was only £36 from Amazon so would save me a bit of money too (not that It would count for much in the grand scheme of this build anyway lol) small fortune! could have bought a pretty decent new car!
Oh I totally missed that you have it working already. "DUH" yeah I wouldn't buy another one either. If you've already got it working on your LAN you've got half the work done (really much more than half) in regards to WLAN. Once you have your ProfiLux up and running hardwire it to your LAN to make sure it's accessible that way. This is merely incase you have trouble with your WLAN you've already confirmed P3 connectivity and wont have to back up to troubleshoot this later. Once that's done simply plug into your Belkin and there's probably not any more "Settings" to change. Restart your PLC software and connect to P3 wirelessly. It's really pretty darn simple.
Just one more thing to try. Disconnect the USB. Use the power lead of the profilux to power the VAP11G (make sure that you do not connect the USB or you will fry the computer) and try again. I had some problems with the USB but it worked fine doing this.
That can´t work for initial setup, it´s for normal work after setup only. Put in the LAN pcable in your router or PC and the USB/power courd into an workung USB socket. Alternatively you can use the power supply from the Profilux - it fits exactly in the socket on the back. of the VAP11G. Then run setup.i set it up like the picture wirus posted on another thread
Bookmarks