-
Socket setup for NR
Hi all
I want to run a Dosing pump as the feeder of water from sump into a nitrate reactor and have a probe measure the redox in the NR. Then what I would like to do is switch pump on when the redox is at level A let's say -150mV and when it gets to -100mV switch the pump off and let the NR work and once the reading is -150 switch dozing pump on again.... Thus keeping the NR happy and working at optimum levels.
Is -150 ~-100 the best range and any tips on how to program this on the p3 with a stand alone Rosing pump being switched via a pab 6 power bar?
Help needed on how to program this function in the P3????
-
Why don't you use the easiest function:
Redox Nominal Value: -150
Redox Hysteresis: 80 (or 100)
Socket function: Redox1 -> Increase value
GHL Iberia
-
Thank you, have just installed the pump and done the programming will monitor for the next few hours.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks