Calibrate Temp

[richard.mayo]

So i had a broken temp probe which before i replaced i manually increased the temp reading my 2 degrees and altered the ADC 1 and ADC 2 data. I made a note of the original ADC data so i could change it back if i needed.

Now that i have replaced the probe with a new one do i need to change the data back to the original (ADC 1 = 721 & ADC 2 = 347) or will the new probe change it manually

Thanks

[Wirus]

Calibration data are for the Profilux electronic itself, not for the probe. So if you change a temp probe, normally no calibration needed.

[richard.mayo]

Calibration data are for the Profilux electronic itself, not for the probe. So if you change a temp probe, normally no calibration needed.

So your saying that i should change the ADC data back to the default for the new probe?

[Wirus]

So your saying that i should change the ADC data back to the default for the new probe?

No idea. Idon´t know why it was changed (normally no one does that) so only the one who´s done that can answer you.

[Blahenazo]

So your saying that i should change the ADC data back to the default for the new probe?

I would say yes. because its the internal circuit of the profilux that gets calibrated . that's at least what GHL says