Power bar PAB driver update failed during upgrade, GHL is not able to detect it, any solution ?
Thx a lot
Power bar PAB driver update failed during upgrade, GHL is not able to detect it, any solution ?
Thx a lot
Do this:
Connect this powerbar only to the ProfiLux, not other PAB-devices!
When the message "Error! No PAB device connected! Try update anyway?" pops up then do exactly this:
- powercycle powerbar
- click "yes" immediately!!! (2 seconds) after powerbar has power again
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
can I proceed this recovery if vc pab ugrade fail as well ? ImageUploadedByTapatalk1316591813.014434.jpg
Problem fixed, thx for your support
Dear Matthias, could you also help me out? Just bought the powerbar 6D-D, installed and programmed it and it's works fine. It just doesn't show me any 'actual currents'. I probably need to upgrade the powerbar but got the exact same problem as whoami. powercycling doenst work.
How can I see the current FW version of the powerbar?
Thank you!!
Jochem
Some system information. Under PAB devices nothing is listed.
***** System report *****
Controller properties
Name: ProfiLux 3 eX
Firmwareversion: 5,11
Device address: 1
PAB address: 17
Serialnumber: 1110052026
Slot count: 3
Level inputs: 3
Sensor 1: pH-value
Sensor 2: Temperature
Sensor 3: Conduct.(S)
Sensor 4: Redox
Onboard 1-10V outputs: 6
Onboard socket outputs: 8
Slot/card properties
Slot number 0
Name: SERIAL
Class: Communication card
Slot number 1
none
Slot number 2
none
PAB devices
Surely not. Only the Powerbar 6D PAB is able to measure currents. The Powerbar 6D isn´t.Just bought the powerbar 6D-D, installed and programmed it and it's works fine. It just doesn't show me any 'actual currents'.
It´s not a PAB device.Under PAB devices nothing is listed.
also on a 6D-D you can't upgrade the FW so don't try
Bookmarks