Power Bar update failed - Help please

[whoami]

Power bar PAB driver update failed during upgrade, GHL is not able to detect it, any solution ?

Thx a lot

[Matthias]

Do this:

Connect this powerbar only to the ProfiLux, not other PAB-devices!

When the message "Error! No PAB device connected! Try update anyway?" pops up then do exactly this:

- powercycle powerbar
- click "yes" immediately!!! (2 seconds) after powerbar has power again

[whoami]

Do this:

Connect this powerbar only to the ProfiLux, not other PAB-devices!

When the message "Error! No PAB device connected! Try update anyway?" pops up then do exactly this:

- powercycle powerbar
- click "yes" immediately!!! (2 seconds) after powerbar has power again

thx, will try tonite & let u know the result.

[whoami]

can I proceed this recovery if vc pab ugrade fail as well ? ImageUploadedByTapatalk1316591813.014434.jpg

[whoami]

Problem fixed, thx for your support

[Joch3m]

Dear Matthias, could you also help me out? Just bought the powerbar 6D-D, installed and programmed it and it's works fine. It just doesn't show me any 'actual currents'. I probably need to upgrade the powerbar but got the exact same problem as whoami. powercycling doenst work.

How can I see the current FW version of the powerbar?

Thank you!!
Jochem

[Joch3m]

Some system information. Under PAB devices nothing is listed.

***** System report *****

Controller properties

Name: ProfiLux 3 eX
Firmwareversion: 5,11
Device address: 1
PAB address: 17
Serialnumber: 1110052026
Slot count: 3
Level inputs: 3
Sensor 1: pH-value
Sensor 2: Temperature
Sensor 3: Conduct.(S)
Sensor 4: Redox
Onboard 1-10V outputs: 6
Onboard socket outputs: 8


Slot/card properties

Slot number 0
Name: SERIAL
Class: Communication card

Slot number 1
none

Slot number 2
none


PAB devices

[Wirus]

Just bought the powerbar 6D-D, installed and programmed it and it's works fine. It just doesn't show me any 'actual currents'.

Surely not. Only the Powerbar 6D PAB is able to measure currents. The Powerbar 6D isn´t.

Under PAB devices nothing is listed.

It´s not a PAB device.

[Blahenazo]

also on a 6D-D you can't upgrade the FW so don't try

[Joch3m]

:madamn, bought the wrong one.

Thanks guys.

Surely not. Only the Powerbar 6D PAB is able to measure currents. The Powerbar 6D isn´t.



It´s not a PAB device.