hey does anyone know how a pab bar should up Dating?
with the new firmware.
and how?
greetings from belgium.
hey does anyone know how a pab bar should up Dating?
with the new firmware.
and how?
greetings from belgium.
Through ProfiLuxControl sfotware. Under menu File -> Firmware - Update PAB- device
GHL Iberia
Do you need to disconnect other units?
I have à error code28 update PAB
Over USB connection.
Last edited by calibraboy; 11.09.2011 at 12:30.
only connect the device which should be updated
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Ok then I plug the RJ45 into the PAB and update.
So it must be done à hope?
Greetings
I don't get it, what if theres more than one PAB? to you do it one at a time? or all toghether?
whan you say onley connct the device which should be update, in this case PAB the update is in the computer
there is no option to connect the PAB direct to it so you need Profilux control as well, so basicly were just talking of disconeccting the
dosing punps?
and what is the difference the latest PAB update to the previes one?
Thanks
during a PAB update:
disconnect ALL PAB devices from ProfiLux
disconnect ALL PAB devices from the PAB device which you want to update
connect the PAB device directly to the ProfiLux PAB port (make sure connecting the PAB device to the PAB port and not in the Ethernet port!)
make sure the PAB device is powered up
the S-Ports (dosing pumps and Powerbar6D without PAB) are NO PAB ports
Last edited by GHL Support; 14.09.2011 at 07:08.
Bookmarks