Hi
ProfiLux does nothing else then sending a voltage signale between 1V and 10V.
The ballast is responsibe for producing a correct brightness which refers to the signal (or percentage).
If there is an issue it is not caused by ProfiLux, its more likely that the ballasts and/or the wiring (too long wires to tubes?) makes a problem.
Are we talking about GHL light bars or about DIY lamps?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks