Programmable logic HELP

[doggydoc10]

If I have a timer set up to dose manually and I have a Profilux doser connected to s1-s4, do I still need to assign that timer to the specific socket that controls each pump?
I tried using prog logi to control timer AND ph increase and then assign the logic to that specific pump but it didnt work????
This is getting to be a PITA!!!!

[doggydoc10]

select function "logic 2" for the socket in question

And I did select logic 2 to socket function but it didnt work.. meaning pump did NOT turn on at timer set up time

[Wirus]

Then there are tree possibilities:

• ph value is too high (this was your target: switch off doser if ph is too high)
• you have done anything wrong
• there is something defective

Due option 2 is in all probability: Show a screenshot of your settings (ph, logic and socket)

[doggydoc10]

ph value was set as follows":
nominal value 8.2
hysteresis .4
alarm activated +/- .5

All equipment is new
I AM SURE I AM DOING SOMETHING WRONG!!!!! LOL
Wirus THANKS FOR ALL YOUR AWESOME INPUT. MUCH APPRECIATED

[doggydoc10]

Thanks to Gareth at Progressive reef problem solved.