Results 1 to 3 of 3

Thread: Firmware Upgrade 5.05? - 5.09 (3ex)

  1. #1
    Join Date
    23.04.2011
    Posts
    5

    Default Firmware Upgrade 5.05? - 5.09 (3ex)

    Had to replace a fault screen for my 3ex today. Thought I would take the oppotunity to upgrade my firmware so saved down my settings for sensors and Profilux Control. Have tried to reload and when i try to reload it says "Firmware version of file and device are different" if I continue it comes up with "types of file and device are not compatible".
    Looking at the sensor and setting files i saved the first line says:
    0, "CODE_SOFTWAREVERSION", 505 (i assume my old firmware version was 5.05)

    Can i extract the info from the sensor file (if so how?) or do i need to buy calibration fluids?

  2. #2
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    Hi

    I guess the P3eX is only recognized as a P3 after replacing the fron PCB.

    Please do the "Hardware-Updgrade eXtended" with PLC (menu extras) first.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    23.04.2011
    Posts
    5

    Default

    Thanks Mathias, that worked perfectly!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •