I just had a read of the wireless interface user manual.
I was wrong saying that it didn't respond to http.
It should if it's configured. Just not the PII, but the WLAN card.
Something that you can check in the PII is that the ip address is actually being set.
This can be checked on the unit, follow the instructions in the user guide for the WLAN card
Or from
http://support.aquariumcomputer.com/...N_WLAN_eng.pdf
Keep in mind that the wireless cannot be secured for the initial connection (no encryption on the wireless)
Then once you have it going, it can be changed to WEP or similar
Sorry for the error above
Bookmarks