Profilux Touch PLC control software

[Himat]

Is there a plc software for the touch, I have the latest firmware Software but cannot find this control.

The Profilux Touch manual makes reference to this.

[TheManicFishkeeper]

Profilux needs to be Running Firmware Version 5.08 or higher to support the Touch, and the software also needs to be 5.08 or above.

You may need to assign your Touch as a PAB device before you can access it in the software.

[Himat]

how do i assign the touch, i have firmware/software 5.09

[Blahenazo]

admistering PAB devices happens on the P3 in the PAB menu . Check the PAB manual in the download section.

[Himat]

I have checked the PAB manual, I have the touch working and displaying, I would like to change the setting using the PLC programme.

i need a step by step idiot guide as I don't see the touch option in the PLC programme.

[Coralleida]

Under System Menu -> PAB -> Assign Devices
Make sure you check the litlle box where it says PTxxxxxx (where xxx is you ProfiLux Touch's serial number)

After that, execute ProfiLuxcontrol and you'll see a new item in your menu on the right

[Himat]

thank you Coralleida

followed your instruction, sorted out now I see the extra menu.

thanks

[M007]

One additional bit, you can only carry out this action directly at the P3 and not via the PC software.