Page 1 of 3 123 LastLast
Results 1 to 10 of 28

Thread: Vortech ecosmart update

  1. #1
    Join Date
    20.12.2010
    Posts
    11

    Default Vortech ecosmart update

    Right after taking me till this morning 2am to figure out that I have to update the vortech controller through the PAB update I have finally got it up and running and gives me firmware 1.01 rf 1.02 and interface 1.02. I updated the ecosmart firmware via the controller to 1.06 but it now tells me both pumps are version 2.02 and doesnt give me the status or what type of pump.

    Can anyone help, is this correct or do I need to change something?

    I am using PLC 5.09 and firmware 5.09
    Last edited by jumboswart; 03.06.2011 at 08:23.

  2. #2
    Join Date
    07.06.2009
    Posts
    738

    Default

    did you try a PAB reset ?

    PAG resetting sometimes helps with getting the right FW versions after a flash

  3. #3
    Join Date
    20.12.2010
    Posts
    11

    Default

    Quote Originally Posted by Blahenazo View Post
    did you try a PAB reset ?

    PAG resetting sometimes helps with getting the right FW versions after a flash
    Will check to see if that works thanks

  4. #4
    Join Date
    12.05.2010
    Posts
    343

    Default

    2 of my pumps say 1.6, another one says 2.01 and then another says 2.02 haha but it hasn't been a problem for me, I would have no idea on how to update the pumps to 2.02

  5. #5
    Join Date
    20.12.2010
    Posts
    11

    Default

    Ok so I found out the MP 60's come with firmware 2.01 and the profilux vortech controller just updated them to 2.02 and they are working. What I am now wondering is why the type shows unknown and there is no status?


  6. #6
    Join Date
    12.05.2010
    Posts
    343

    Default

    I have 5 mp40 and none of them show a status but all show type

  7. #7
    Join Date
    20.12.2010
    Posts
    11

    Default

    Quote Originally Posted by richard.mayo View Post
    I have 5 mp40 and none of them show a status but all show type
    They work so I suppose I shouldnt complain

  8. #8
    Join Date
    14.10.2009
    Posts
    86

    Default

    I have the same issue, I have just connected my MP60 and updated the firmware to 2.2 but still see the Type unknown and status blank - any ideas as this was one of the reasons why I wanted the controller, to be able to monitor the pump status. Regards, Andy

  9. #9
    Join Date
    25.09.2009
    Posts
    62

    Default

    Try powering off the pumps for a couple of minutes, then reconnect the power to them so the PAB module has to 'look' for them again.

  10. #10
    Join Date
    14.10.2009
    Posts
    86

    Default

    It didn't work for me Mark

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •