Hello
I upgraded my P3 to P3ex and after a few failed software upgrades noticed that my temperature is off a couple of degrees.
I do not have the original ADC values. If they are consistent across the production line, can you please post the appropriate values?
At the moment, when I use 721 and 347, my temperature is off by 0.5c too high. For which I compensate with the PLC function.
I also recalibrated my conductivity probe with the profilux 50ms solution.
1. Select 50ms cal fluid and temp probes instead of manual input,
2. Both temp and cond probes in the air,
3. Both probes in calibration fluid,
4. Save calibration
When I then read the values of the calibration fluid, I would expect 50ms but I get 53ms... I tried to calibrate again but get the same results...
Any thoughts?
---
I am here: http://maps.google.com/maps?ll=48.143145,11.538176
Bookmarks