Hi.

I am the happy owner of a Profilux 3.

The problem is about lighting connections:

My lighting device (LiTeCo, Germany), is a 4x T5 (Dimmable) + 2x MH + a 2 channels Moonlight LED bar (Dimmable).

What I want now: I want to be able to use the following separately:

  • 2 x T5
  • 2 x T5
  • 2 x MH
  • 1 x Channel Moonlight
  • 1 x Channel Moonlight


From the lighting device leaves 2 cables (see the first and second photo). 1 for DALI socket and 1 for L1L2 socket

From moonlight bar leaves a cable, going to L3L4 socket.

Using these connections, I can control:

  • Via Illumination 1 Channel: 2 x MH
  • Via Illumination 2 Channel: Nothing but I can hear a click of a relay to open or close
  • Via Illumination 3 Channel: 2 x T5 + Red LEDS of the moonlight bar
  • Via Illumination 4 Channel: 2 x T5 + Blue+White LEDS of the moonlight bar


As you can imagine it is not acceptable, because the 4xT5 are still lighting in the evening.

If I connect the cable of the moonlight bar on L1L2 socket, and the cable of the lighting device on L3L4, I have a more acceptable result:

  • Via Illumination 1 Channel: Red LEDS of the moonlight bar
  • Via Illumination 2 Channel: White LEDS of the moonlight bar
  • Via Illumination 3 Channel: 2 x MH + 2 x T5
  • Via Illumination 4 Channel: 2 x T5


This is the configuration that I use at the moment, but it is still problematic, because I cannot have 4 x T5 lighting, without MH strong light (Early morning, or Late evening).

Is there any suggestion? Photos are following




Thank you in advance

Christos