Tunze 6105 variable stream
Hello,
Can someone explain how the pump is regulated by the Tunze Port Ln?
I connected a pump Tunze 6105 on the port with the cable L4 Profilux Tunze 2.
I set the pump on PLC as follows:
Prefs pumps:
- feed pause: off
- Voltage: 3 min / 8 max
Prefs Pump Group:
- Mode: Permanent
- Waves: No waves
Prefs 1.10V (L4):
- Function: current pump / Nr 1
- U min/max: 3 / 8
Even if I change the maximum and minimum% of flow, the pump always operates at the same rate.
The voltage monitor 1.10V indicated in the L4 port is always 6.9v.
This voltage does not vary.
The pump does not stop if I press the ESC key (feed pause).
Thanks...
Profilux 3 - Tank: 200cm x 50cm x 70cm - Cichlid Malawi
Bookmarks