I have been very patient (or lazy!) with my LED build. I do have all the LEDs for maybe almost a year now, as well as over 40 Meanwell drivers. I am selling off the drivers as I do not believe that these will work well given their relative inefficiency. This would not be a problem if I just wanted to run 8 drivers, but over 40! Too much current because of the poor power factor correction.

Anyway, I've been looking at the ELDO site and really liked their drivers, very flexible. Especially the PowerDrive AC mains driver. It has four outputs each programmable for up to 1050mA and up to 60 volts. The only limiting factor is total power must be less than 100 watts. And it is a DALI driver which would make dimming functionality much simpler, I think. Am I correct in assuming this will work with a P3ex with a DALI card? I wanted to get some official word from here before ordering because they are fairly expensive and I really don't want to waste the money and effort like I did with the Meanwells.

Here is a link to the PowerDrive's data sheet:

http://www.eldoled.com/dsheets/Datas...eries_V3_3.pdf