Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: filter jumps into mode "auto-off" intermediately

  1. #11
    Join Date
    13.08.2010
    Posts
    42

    Default

    Quote Originally Posted by Frank View Post
    @akatar

    We can't reproduce this problem here. We have tested this on our EHEIM filter and there is no problem with the AutoOff...

    I've forced our filter into AutoOff by setting no waves at 100% until the ProfiLux reported ***. Then I've activated sine waves again (range 1%..100%, 60s) and there was no problem.
    like i said i offerd you to sent you my eheim pomp so you can test all you want.
    my pump is runing at 30% and it's working. when i raise it to 50% the pump goes into auto off and will not respond to "go to 30%"
    that will takes some time, (power off and power on will help).

    i guess it was a waste of money to pre-order and buy the eheim controller.
    i will go back to off/on with feeding pause

    thanks for youre time.

  2. #12
    Join Date
    19.02.2009
    Posts
    2,976

    Default

    @akatar
    Sorry, but I don't understand your post.

    Do you need to remove the power of the filter to get out of this mode?
    I'm sure you don't forgot to save the changed flow value at PLC.
    Are you sure the filter isn't running in calibration (green LEDs running up and down on the filter) after you set the Filter to 50%?
    If a constant flow (no waves) set up for the EHEIM the flow is only transmitted every minute - if the flow was not changed.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •