filter jumps into mode "auto-off" intermediately

[GHL Support]

The real state is known by the EHEIM-Controller and by the ProfiLux, but all states except normal are displayed as ***

Only if the filter is calibrating, there are no commands allowed. And only in this case the EHEIM-Controller sends no commands to the filter.

[akatar]

when settings are to high, i can not change them because the filter is ignoring the command.
and we sent a lot of mails regarding this poblem.
when choosing feeding pause (pump must go to 1%) and status is unkown. pump goes to 1% and 2 seconds later to full speed (1 led on, 2 secs later all leds on)