How to make sunrise on plus II ?

[Rasmusm]

Hey

I have the profilux Plus II and a ATI powermodule 4x80w.
I bought the LBF-AP thing and it works.
But I cannot figure out in the profilux software how to do the sunrise and sunset?

Right now I just wanted it to run on 30% light because its newly started freshwater tank. And then do a sunrise over 45min to 30% light. Is it possible?

Kind regards Rasmus

[GHL Support]

Have you already assigned the lamp to the 1-10V-interfaces under System/1-10V-interfaces/e.g. funtion of L1 = illumination 1?
Then you can go in the illumination menu into the corresponding illumination e.g. 1 and define the dimming curve. If you would like
to have the sunrise started at 8:00, then the setting would be
1 08:00 0%
2 08:45 30%
...
Then the lamp would dim within 45 minutes to 30% (please note that this information is valid for firmware > 5.00.

[Rasmusm]

Ah thanks again Carolin!
I figured it out now :-) Had to assign a timer aswell to shut off the light through my powerbar.
So powerbar activates at 13:00 and same as light starts at 0% goes to 30% 13:45 until 21:15 then 0% at 22:00
Its cool now :-) Now to figure out the cloud thingie hehe..