improvement: Illumination screen

[Gilles]

Hi, 2 tips:
1) Make it possible to copy data from 1 light to new light, because when i have upgraded my firmware i have to reset all settings.
2) Add an "Enabled" switch, since in some circumstances you want to disable lights for a period but not loose all settings, so if disabled, the light will not switch on.

[Mathias-Steffen]

Thanks for your feedback. What do you mean with "disable lights"? Did you try the "Manual Illumination" Mode?

[Blahenazo]

I think he means a way to just disable a channel with a checkbox.
Instead of decoupling the illumuation channel from a socket of L port, dali controller.

[Gilles]

yes that is exactly what i mean. For instance; sometimes you just want to experiment with light (less light for 1 month or so), or you have algue issues and you would like to disable all lights (blue algue), but not remove wires, etc. So if there was an option next to each channel (or DALI group even..?) to disable that specific channel?

For instance:


In my case, i have DALI and all my EVG's are on 1 power socket (looped).

[Gilles]

bump?

[Mathias-Steffen]

Its not forgotten, but still on our user-wishes list. But this list is looong... Please give us a little more time to come back to you.

[-Scott-]

No offense but I would imagine something like disabling the lights (even something as simple as a check box) would be low on the list. When I want to disable my lighting I use the UNPLUG L1L2 option located on the back of the Profilux unit.

[Gilles]

Not everybody is using L1L2 ports, i am using DALI protocol, so unplugging that disables all lights. It is not for all lights, but seperate lights