EHEIM-Controller - WICHTIG! LESEN!

[MartinS]

Here almost the same problem. The View II displayed:

EH: 148l 180 days
EH: 149l 180 days
EH: ***l days
EH: 349l 180 days
EH: ***l days
EH: 349l 180 days

So it toggles. The filter keeps (fortunately!!) running.

After a reset of the filter the status in PLC changes between 'unknown' and 'normal'.
View II toggles:

EH: 316l 180 days
EH: ***l days

Btw, what does '180 days' mean?

[akatar]

the filter keeps running, but will not respond to commands.

[MartinS]

How do you give commands? Directly on the filter? I can't find a way by using PLC...

[akatar]

i simply use feeding pause, the eheim must go back to 1%. as set with plc
sometimes that works, but when display reads ***1, nothing happens

[GHL Support]

Thanks for your feedback. We will check this...

[akatar]

i guess it's already checked.
it has been reported for a couple of weeks now

[akatar]

Thanks for your feedback. We will check this...

thanks for you're post.
i had the idea that everyone at ghl were ignoring us

[GHL Support]

If the ProfiLux displays *** the EHEIM filter is in an state were commands are not allowed.
This state could be calibrating or something else.
We send only commands, if the filter is in normal operation.

Could you report us your settings for the EHEIM filter and the corresponding pump setting?

[akatar]

Frank,
what do you need to know exactly?
i did sent you a couple of mails with information you asked..

what information did i forget?

[Matthias]

Akatar,

yesterday I released a new version of ProfiLuxControl (5.0.5.4), with only 2 slight changes: saving of pump descriptions fixed, and more important for this case, the EHEIM-Status is read out more detailled.

Could you update to PLC 5.0.5.4 and tell me what status is shown when the *** appears?