AI has now released the new firmware for their controller to have separate control of all 3 channels...white, blue , royal blue
when will the profilux be capable of handling the 3 discrete channels?
AI has now released the new firmware for their controller to have separate control of all 3 channels...white, blue , royal blue
when will the profilux be capable of handling the 3 discrete channels?
+1
I was just going to ask the same question on RC but thought I would check here first.
we got feedback from Aqua Illumination - they don't want to give us the technical details before January (no date available so far)
-> we can't do anything in regards to our firmware at the moment
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Has anyone the new 3 channel AI lamp yet?
if yes - please send me a PM
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
pm sent
Hi Mathieus, I have new AI light, can you assist with control of all 3 channels?
Please sent a PM to Matthias - thanks.
Done, I have discovered a problem, when I set the Illumination 1 & 2, to 100%, on the Display is only shows 30% & 28%? Is this a bug? Can the light be properly controlled?
I don't understand this post
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Hello Matthaius what I'm trying to say if I configure Illumination 1&2 in pcl 5 to 100% & save the configuration to the p3, on the display of the p3 it only shows Ilimination 1&2 at 30% & 28%, I don't see it ever going to 100%. illumination 1 is configured for white led & Illumination 2 is configured for blue led.
Bookmarks