Hello, I have sold my GHL dim 80Watt T5, to a person who has no profilux yet. He will temporarily use a flora mate unit till he switch to PL. Which 2 of the 6 colored wires make dimm possible on 1-10v?
Thanks,
Jan
Hello, I have sold my GHL dim 80Watt T5, to a person who has no profilux yet. He will temporarily use a flora mate unit till he switch to PL. Which 2 of the 6 colored wires make dimm possible on 1-10v?
Thanks,
Jan
This is not so easy, a signal of 12V must be applied to the relay wires. The 1-10V socket is described in the manual of "EVG-AP".
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Where does the 12volt come from in a normal Profilux setup?, is it supplied by the ballast or the profilux
Last edited by mdanielse; 24.08.2011 at 12:26.
You have read the manual of "EVG-AP"?
Bookmarks