Results 1 to 3 of 3

Thread: DE Lightings T5 Unit control

  1. #1
    Join Date
    31.10.2010
    Posts
    2

    Default DE Lightings T5 Unit control

    Hi
    I have 2x T5 DE Lighting units I am looking to control with my Profilux 3. The units are wired to plugs and I am unsure what module I would need for control.
    Thanks in advance

  2. #2
    Join Date
    19.02.2009
    Posts
    2,976

    Default

    Hello,
    are these lamps simply T5-tubes?
    Then you have the following options:
    -switch them on/off via our powerbars
    -dim them by using an adapter like our LBF-AP. Of course you will need at first dimmable ballasts.
    Then you can connect them to LBF-AP, it provides two channels but is without internal shut-off.
    The board comes along with a control cable that is plugged into a 1-10V-interface at the ProfiLux.
    To achieve the shut-off, you must put the power plugs into a Powerbar.
    In case the lamps have to be opened, e.g. to build in dimmable ballasts, then you can also use the board EVG-AP-2F
    (this has also two channels and internal shut-off, but has no housing, so it has to be installed inside the lamp)

  3. #3
    Join Date
    31.10.2010
    Posts
    2

    Default

    Thanks for the reply and details.

    Yes they are simply T5 Units, ie non dimmable. A powerbar will do the job. Thanks for the reply.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •