Pab bar firmware update failed

[lalasfish]

Hello

tried to upgrade firmware of pab bar

using latest software version
plugged only pab bar to be updated to s port

when i press update firmware status bar was empty

i wait for about 20 minutes then nothing happened
i killed the process
now pab bar is dead... profilux sais that pab bar is transparent...
is there anyway to recover my pab bar??

Thank you very much

regards

Christos

[lalasfish]

ok update of status

after powercycle the pab bar and the PL my bar is working Thank God.. when i do manual override from the software sockets open and close so pab bar must be working


tried to updade again but sais error28 ... and then no pab bar connected ......what i'm doing wrong here?????

[richard.mayo]

same problem, can we get some help

[GHL Support]

We need more Infos:

In which way the ProfiLux connected to PLC (RS232/USB/LAN)
Which version of PLC, firmware version of ProfiLux 3 and PowerBar6D-PAB

Avoid mix up the designations of the ports, devices, ...
The PowerBar6D-PAB (if this is a PAB powerbar) is only connected to PAB - not S-port or someting else

[richard.mayo]

I got mine to work, just power cycle the PAB bars and also the Profilux

[jumboswart]

I have a PAB and it has firmware 1.1 and tried to update to 1.6 it runs through to deleting flash then stops and error message failed to update appears. I connect via rs232 and have plc 5.9 and firmware 5.09. Can you please advise?

[Matthias]

only the PAB-device, which has to be updated, shall be connected during the update