4 level sensors

[deepblue]

Is it possible to controll 4 level sensors with profilux II ex ?

[GHL Support]

No, only 3.

[deepblue]

i want to use 3 sensors to control my ro-di with 2 magnetic valves.
When the lowest sensor is on,it should open the 1st valve and start to fill ato tank untill is full (middle sensor).The 3rd sensor is for safety purpose and when is on,it should activate the 2nd valve and shut it in case that the 1st valve get malfuncioned-jammed.The second valve stays open untill it gets electricity.

How to program this?
PS.Now I am missing the 4th sensor for my sump level ,have you any suggestions?

[Luisagos]

i want to use 3 sensors to control my ro-di with 2 magnetic valves.
When the lowest sensor is on,it should open the 1st valve and start to fill ato tank untill is full (middle sensor).The 3rd sensor is for safety purpose and when is on,it should activate the 2nd valve and shut it in case that the 1st valve get malfuncioned-jammed.The second valve stays open untill it gets electricity.

How to program this?
PS.Now I am missing the 4th sensor for my sump level ,have you any suggestions?

Remove sensor 2 and put a timer on sensor one. You need to calculate how long would it take to reach to sensor 2 level. You still have sensor 3 for back up.
That should clear one of the sensor up for something else, till we get Profilux III.

[deepblue]

can you help me to program this

[deepblue]

can you explain how to programm when level 1 is low to turn on s6 on powerbar and to svitch s6 off after 4 hr and to stays off until is level 1 low again

[deepblue]

Nwm i figure it out