Now our new led-controller "LEDControl1" is available.
It enables you to dim a LED-lamp with 700mA and max. 20V with a 1-10V-interface of the ProfiLux.
Plugs and sockets are compatible to TMC/Aquaray lamps.
Now our new led-controller "LEDControl1" is available.
It enables you to dim a LED-lamp with 700mA and max. 20V with a 1-10V-interface of the ProfiLux.
Plugs and sockets are compatible to TMC/Aquaray lamps.
Will this unit (LEDControl1) connecterd to a L - port?
And how will it look like in the ProfiLux II, Firmware 4.06, English when you should program the unit.
yes, is connected to L y
Programming: like all other dimmable lamps, there is no difference
First program the illumination run x
Then assign illumination x to L y
I can buy from a friend ledtubes
can i controll them with the (ledcontrol1) Moving through the L1/L2 L3/L4
the data from the LED tube are
Replacement for fluorescent tube 150cm 58 watt
Number of LEDs: 420
Fitting size: G13
Lamp Size: L.1500mmx? 30mm
Consumption: 18 watts.
Voltage: 220 to 240 volts.
Degrees angle: 120?
Light color: warm white (3000 - 3500K)
Place in existing luminaire after removal USA and starter
Burn Times:? 50,000
Warranty: 2 years.
thanks for the reply
no, you can't since the LED tube you mentioned is a replacement for a standard fluorescent and it must be operated with high voltage
LEDControl can control LED lamps with 700mA and 20V max.
that's a bummer
is there any other way to control this kind of ledtube with the profilux?
For example with a led driver? and are there led tubes with 700mA and 20V max. ?
Last edited by marco; 30.05.2009 at 16:12.
Is this a LED ballast or just the controll unit?
How many LED´s can you use if i have one called
Forward Voltage typ. 3.3V (max.3.9V)
(Cree XR-E 7090 R2, white, 242 Lumen)
ballast or control unit? I would say both
20V : 3.9V => approx. 5 LEDs in a line
but the current is more importnt - your LEDs must draw a current of 700 mA
Bookmarks