Goodafternoon,
My paludarium is controlled by a Profilux Plus II. The PropellerControl is used for extra cooling the paludarium in summertime - when necessary - by means of small fans.
A 1-10V interface is assigned to the airtemperature sensor. So far so good.
(Suction hot air from inside to outside.)
Now, room temperature is dropping and I like to use the whole unit in reverse, that is to say, blowing hot air from the illumination space into the paludarium.
But unfortunately there is no "invert" setting for the airtemperature. That is to say: real temperature lower then desired temperature gives output on the 1-10V interface.
Is there a solution?
(I prefer not to use a switching output.The fans are computer fans.)
Thanks in advance,
Wim
Bookmarks