Hello
I have a P3 with firmware 5.03b
PLC software 5.0.3.1 Dosing unit, PB, Probes- PH, conductivity,temp
Communication LAN +USB card I only use LAN
Slot 0 serial port
slot 1 cond+uUSB
slot 2 serial port added today. I use serial port for AI Led modules
Connection
PC to Profilux through LAN, Profilux to SMS module via serial cable (grey colour from GHL)
Today added the SMS module. GHL had already installed Firmware 2.01
red light slow flash one in about 4 sec
Both green contionously on
Yellow continously on
Now the problem
Took many attempts to programme SMS module as the screen Freeze when i try to save information. I have to disconnect the serial cable or restart PLC progrmme.
After 4-5 hours of connecting and disconnecting i found the information was getting saved in the PLC but don't know if it is saved in the P3
When i Test no message goes through.
I get error message 28 and 50
I can see the green bar battery charge and status as ready.
Finally i get NO connection to the SMS module at all. All I see is the SMS module on the right side of the PLC but when i highlight it the whole screen freeze?.
I have deleted my email connection to both the PC and P3 thinking it may be causing the problem. But that has made no difference.
NEED GHL support HELP
Thank you
glanka
Bookmarks