-
You need to unassign the VorTech-Controller at the ProfiLux (don't forget to save), and then you must reassign your VorTech controller.
After then reconnect with PLC and the new firmware version should appear.
-
Thanks that worked but now im onto the next problem, the Controller Interface is 4.7 which when i click upgrade (and choose 1.02, why is it a smaller number) it goes through the upgrade and gives me a success note but it still stays on 4.7??
-
OK now it gets stranger, just unplugged the controller as i thought a reset never hurt...
Now the FW shows 1.01 but the interface and RF show 0 and it errors out when i try to update......
is anyone else have the troubles i am???
-
anyone.... im about to smash this thing against the wall
-
Hello, can i please get some help?
-
Try another network cable. The PAB cables need to be the correct one. I had a friend who got one and he had 3 cables. One didn't work at all, one worked but wouldn't update the firmware etc and the last one worked perfectly. Check with your dealer to make sure your getting the right type. I believe it's straight through normal cable with no crossovers.
-
You should make a clear difference between the firmware version of
- the VorTech-Controller (latest: 1.01)
- the controller interface (latest: 1.02)
- the RF module (latest: 1.02)
- and the pumps
I think you had a version 0.47 on the controller interface (not 4.7) and you have updated to 1.02
-
OK tried a new PAB cable from my PAB power bars, still not working.
This is what is have
Firmware Vortech Controller 1.01
Firmware Controller Interface 0.
Firmware RF-Module 0.
When i try to update the Controller_Interface_OS (V1.02) i get a "Error! Couldn't start update" error and the same when i try to update the RF_Module_OS (V1.02)
I have tried un-assigning and re-assigning, restarting the P3EX, restarting the controller... nothing is working.
On the controller the orange light is blinking in time with the powerbars and the green light is solid, no blue and red lights are on.
Last edited by richard.mayo; 28.10.2010 at 10:32.
-
I have noticed that when i click on the Vortech Overview in the software that the orange light on the powerboards and the Vortech Controller stop and then after a few seconds blink and then come quite speratic with no real timing, as if there is a connection problem
-
can anyone help with my new problem?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks