this is not a PAB connection problem because the firmware of the VorTech-Controller is read correctly, that the firmware of the internal RF-module is not displayed correctly shows that the communication inside the VorTech-Controller (between our microcontroller and the RF-module) is not working
the only reason for that I could imagine is that the RF-module isn't plugged in correctly, but you said you already tested this
I have no idea what is going on, I believe further tests and experiments are a waste of time
-> only solution: contact your retailer, I think the VorTech-controller must be checked and/or replaced
your retailer is welcome to contact me personally for further support
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks