Hello,
I just noticed I was running version 1.00 and 1.01 on my powerbars, what is the current procedure to update the firmware on that single powerbar?
I'm running 5.03a on the Profilux, 1.02 on the Ex Box
Hello,
I just noticed I was running version 1.00 and 1.01 on my powerbars, what is the current procedure to update the firmware on that single powerbar?
I'm running 5.03a on the Profilux, 1.02 on the Ex Box
hello
where can you see the firmware version of the powerbars???
i always wanted to see what version i run on mine
In the new Firmware 5.03b you could see the Firmware version of the PAB devices on the ProfiLux itself.
This new ProfiLux menu entry is found at System->Configure PAB->PAB information
In PLC 5.0.3.1 you coud find the info at enty System. In the device tree expand PAB entry and select the PowerBar
Last edited by GHL Support; 22.09.2010 at 07:45.
What is the current procedure to update the firmware on Pad device?
Hello Frank
When i go to System the configuration button and the firmware-update button are grayed out.... cannot press them... ?????????
there is a menu "Firmware update PAB device" under "File"
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks