is available in our downloadcenter for PII and P3
is available in our downloadcenter for PII and P3
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
because I had to look it up anyway
Version 5.03b
- new
- support for VorTech-Controller (affects ProfiLux 3 only)
- display of PAB-components in ProfiLuxControl (affects ProfiLux 3 only)
- timers: correction of switching around 0:00 at certain days of week
- count of allowed files increased to 100 (affects ProfiLux 3 only)
- improvement of connection over LAN (optimization for VPN, MTU changed) (affects ProfiLux 3 only)
- problem solved: calibration of some cards in ProfiLux 2 was not possible
- known Bugs
- none
- not yet supported
- analysis of the measured currents in Powerbar-PAB (affects ProfiLux 3 only)
- settings with Webserver, at present oly status display (affects ProfiLux 3 only)
- PAB-administration over ProfiLuxControl, now only on the device (affects ProfiLux 3 only)
After upgrade Profilux wouldnt see Exp box.
After assing Exp box under Config PAB i still dont see Exp box sensors. i did reboot both controller and Exp box.
i just reset PAB and assing again, still nothing
Last edited by mshur; 22.09.2010 at 01:36.
Other problem!
L-ports are not working either!
My Tunzes and Breez-fans are dead!
I gues i have to go back to 5.02 for now
I've checked the PAB setup: I can't see any Problem.
Do you have made a PAB Systemreset (ProfiLux menu System->Configure PAB->PAB Systemreset) before you assign the EXB again?
After assigning the PAB devices are the devices checked if you go again to the ProfiLux menu System->Configure PAB->Assign devices ?
Could you see the EXB sensors after disconnect and reconnect PLC (5.0.3.1)?
L ports checked and working. Do you check (all) your settings after the update?
Frank,
Just did Pab system reset---Assing devices-SAME PROBLEM. I cant see any probes from ETB on my Profilux-View2 or PLC.
Correction: L5L6 dont work those are L-ports on EXB.
I double checked and i have later firmware 1.03
For some reason there is no connection from Profilux to EXB,but if i go to system menu i can see EXB there with serial number and when i reset it gives me OK.. I dont understand whats going on..
I would revert back to 5.03a to see if everything comes back the way it should
I did jump from 5.02 to 5.03b , maybe this is mistake, but i dont see why..
Can i go back to 5.02?
dont know, but I would evert back to the working version of the firmware
Bookmarks