Firmware 5.03b

[Matthias]

is available in our downloadcenter for PII and P3

[Blahenazo]

because I had to look it up anyway

Version 5.03b
- new
- support for VorTech-Controller (affects ProfiLux 3 only)
- display of PAB-components in ProfiLuxControl (affects ProfiLux 3 only)
- timers: correction of switching around 0:00 at certain days of week
- count of allowed files increased to 100 (affects ProfiLux 3 only)
- improvement of connection over LAN (optimization for VPN, MTU changed) (affects ProfiLux 3 only)
- problem solved: calibration of some cards in ProfiLux 2 was not possible
- known Bugs
- none
- not yet supported
- analysis of the measured currents in Powerbar-PAB (affects ProfiLux 3 only)
- settings with Webserver, at present oly status display (affects ProfiLux 3 only)
- PAB-administration over ProfiLuxControl, now only on the device (affects ProfiLux 3 only)

[mshur]

After upgrade Profilux wouldnt see Exp box.

[mshur]

After assing Exp box under Config PAB i still dont see Exp box sensors. i did reboot both controller and Exp box.

i just reset PAB and assing again, still nothing

[mshur]

Other problem!
L-ports are not working either!
My Tunzes and Breez-fans are dead!

I gues i have to go back to 5.02 for now

[GHL Support]

I've checked the PAB setup: I can't see any Problem.

Do you have made a PAB Systemreset (ProfiLux menu System->Configure PAB->PAB Systemreset) before you assign the EXB again?
After assigning the PAB devices are the devices checked if you go again to the ProfiLux menu System->Configure PAB->Assign devices ?
Could you see the EXB sensors after disconnect and reconnect PLC (5.0.3.1)?

L ports checked and working. Do you check (all) your settings after the update?

[mshur]

Frank,
Just did Pab system reset---Assing devices-SAME PROBLEM. I cant see any probes from ETB on my Profilux-View2 or PLC.

Correction: L5L6 dont work those are L-ports on EXB.

I double checked and i have later firmware 1.03

For some reason there is no connection from Profilux to EXB,but if i go to system menu i can see EXB there with serial number and when i reset it gives me OK.. I dont understand whats going on..

[boboxx]

I would revert back to 5.03a to see if everything comes back the way it should

[mshur]

I did jump from 5.02 to 5.03b , maybe this is mistake, but i dont see why..
Can i go back to 5.02?

[boboxx]

dont know, but I would evert back to the working version of the firmware