Setting up PROFILUX 3ex FW:5.0.3a and PC 5.0.31, Never updated the powerbar firmware, not sure where the fw version is for the powerbar.
I connected 2 Powerbars 6D USA directly to the PROFILUX 3ex. If following the manual, it says to connect the PAB cable to one of the L1/L2 or L3/L4 ports in the P3. First the ethernet cable that came with the unit doesnt fit into these ports(cable to big to fit into these RJ45 ports). So the only option was to connect the powerbars to the "NO NAME" ports mentioned on the manual as 15 & 16. Once connected the powerbars do work but after configuring the lights in ilumination 1(on/off settings- ok), sockets S1(ilumination 1). When the time for the lights to turn on...both POWERBARS S1 turn on. So should i connect the POWERBARS differently??? should they be connected in a daisy chain instead of both powerbars connected directly to the P3??
Bookmarks