Wave using Resun Pumps & profilux

[Vatso]

Wave using Resun Pumps & profilux

[diverdutch]

Wave using Resun Pumps & profilux

Yes nice but how does this work? So us the connection to the profilux..... setting / connection cables ??

According to Resun they don't support wave control by 3th parties?

[Vatso]

It's it connected to the Profilux & being controlled by the profilux the sine wave & timing.

I do not use the Resun controller it's rubbish in my opinion

[diverdutch]

It's it connected to the Profilux & being controlled by the profilux the sine wave & timing.
I do not use the Resun controller it's rubbish in my opinion

Excelent, however how did you (cable pares) connect the Resun pomp to a profilux cable? Which 1-10V did you use (tunze uses 3 -8V)?
Could you give more data, because this realy helps people when using Resun in accordence with Profilux.

[Vatso]

I am busy working on a 24V output - 1 - 10V controller. I tried using a Pulse Width Modulation driver but it does not work on Resun Pumps!

So I used a relay connected to the relay out on L1 & L2 of the profilux