Ich habe einen ProfiLux 3 ex, ProfiLux Control 5.0.2.5, einen PC mit Windows 7 (64-bit), nur USB-Anschlüsse.
Ich wollte auf die Firmware 5.02h upgrade und erhielt einen Totalcrash. Eine Systemherstellung mit

1. download http://www.aquariumcomputer.com/Download/Flash-FR.zip
2. save it somewhere you will find it, no installation required
3. start "flash.exe"
4. select "MB91F467D" as controller, 4MHz, navigate to the firmware file (click "open")
5. check the interface (under "set environment")
6. disconnect ProfiLux 3 from power (it is not necessary to open the enclosure and to set a jumper like it was ProfiLux II!)
7. now click "full operation" - ProfiLux still has no power!
8. plug in the DC-connector - ProfiLux has now power again and the download should start

schlägt fehl; nach der Anzeige "Please push RESET BUTTON on user board" passiert nichts mehr.

Ich habe auch die Methode mit einem Jumpber probiert aber ohne Erfolg.

Wer kann mir bitte mit einer genauen Anweisung helfen, die Firmware einzuspielen?
Ist es es erforderlich, dies mit einem RS 232-Kabel zu machen? Welchen Converter RS232-USB soll ich verwenden?

Vielen Dank für die Unterstützung!