Please can I get a copy of the 10V port Schematic
I am looking at a DIY DC pump
Please can I get a copy of the 10V port Schematic
I am looking at a DIY DC pump
the easiest way to access the 1-10V-interfaces of the ProfiLux is using the product LBF-AP
http://www.aquariumcomputer.com/Syst...cessories.html
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Thanks for the info but I am going to be making my own controller & need to know which wires do what on the 10V cable. which is positive & which is neutral?
Pin Function Color
1 +12V Black
2 Dimming intensity channel 1 Brown
3 GND Red
4 On/off channel 1 (relay control) Orange
5 Dimming intensity channel 2 Yellow
6 On/off channel 2 (relay control) Green
http://www.aquariumcomputer.com/Foru...-EVG-AP-2F-HIC
So I will be using Pin 3 & 2 - I want to change the voltage using these 2 pins to my DIY controller.
So if I connect my multi meter to the profilux on pin 3 & 2 I will be able to see voltage 0 - 10 when a pump pulses?
Mark
yes pin 2,3 or 5 depending on the channel you want to use like L1 = 2, L2 = 5, L3 = 2, L4 = 5 etc.
Thank you so much boboxx - so L1 & L2 can be run from one Port & L3 & L4 from another port - IE 1 Port can run 2 x 10v devices
yes thats correct, each L ports have 2 control line
thank you boboxx
how do I use the relay control? pin 4 "Orange" does is send a signal out is so how many volts? would i connect pin 3 & 4 to a relay to switch it on / off?
thanks
Mark
That I'm not sure, but you could mesure it... it probably stays high or low... do not connect them together
Last edited by boboxx; 28.07.2010 at 20:47.
Bookmarks