Screenshoots for Tunze pumps set

[Alfonso]

I have 2 Tunze Stream 6105 one on the left and one on the right of the tank and I'd like them to work separately for 2 minutes starting from minimum power arriving maximum power.Could you please send me screenshoots for this setting?Thank you.

[Matthias]

for example like this:
tunze.jpg

of course these settings have to be finetuned for your needs

[Matthias]

don't forget to set the function of the 2 1-10V-interfaces (e.g. L1 and L2 or L3 and L4) to "current pump 1" and "current pump 2"

[boboxx]

and to set the min voltage to 3v and max to 8v

[Alfonso]

for example like this:
tunze.jpg

of course these settings have to be finetuned for your needs

Thank you Matthias

[Alfonso]

and to set the min voltage to 3v and max to 8v

Thank you for your advice Boboxx could you please let me know where I must set this data?

[Alfonso]

don't forget to set the function of the 2 1-10V-interfaces (e.g. L1 and L2 or L3 and L4) to "current pump 1" and "current pump 2"

Since I have all the L port empty behind the Profilux 3ex and since I dont like to have too many cable around may I connect one pump in one L port and the other one in the other L port without using the Y adapter?

[Blahenazo]

offcourse you can.

I've been doing that since I got my p3 ex

[boboxx]

the voltage is set in PLC in System > 1-10V Iterface

[mshur]

For some reason my 2 pumps wouldnt work on Sequence 1 or 2. they only work on permanet or perm opposite mode. what could be possably wrong?
when i set on Sequence 1 i can see state is counting % but, pumps are dead.