View II - Socket status?

[instantsquid]

Hi there,

I have a View II connected to my Profilux Plus II Ex. On the right hand side, it displays numbers which (I think) correspond to certain sockets being turned on.
But not always! It only shows whether the first four sockets are on or off, even though there are 12 sockets connected to the computer.
Have I understood this correctly? As it stands it's kind of "half useful" but frustratingly not a decent solution.

Ian.

[Matthias]

it shows the state of the first 8 sockets, there is no place for more

any suggestions how to do it better?

[instantsquid]

Hi Matthias,

Thanks for the reply. I hadn't noticed that it was the first 8 sockets - probaby because sockets 5-8 don't turn on very often in my system!

Off the top of my head - could the display not rotate through all the sockets regardless of state, and show the ones that are active with either with a box around them, or perhaps the background / foreground colours reversed?

Ian.

[garybuk]

Im glad this came up (sorry to hijack) i just set mine up too and wonderd what the numbers are for? but my numbers stay they same 26/37/48??? any ides?

[kidney514]

That means that socket 2-3-4-6-7-8 are on!

[Matthias]

correct

for the new firmware 4.06 I changed the display of the socket status

it is now rotating and shows all 24 sockets

[APCP]

correct

for the new firmware 4.06 I changed the display of the socket status

it is now rotating and shows all 24 sockets

Hi Matthias,
this shoulld solve's my problem as wel, seen as i have dosingpumps on S1-S4 digital, now i should be able to see all socket status again.
Thanks i will try it out ASAP.

Regards
Piet