ATO set up instructions?

[diverdan]

I am attempting to set up my ATO system with the P3. I have looked in the manual and cannot find any. Is there a diagram or instructions anywhere? Thank you.

[Blahenazo]

ATO can be implemented very differently depending on your needs.
1 , 2 , 3 sensors , auto, manual, adding salwater or non salted water depending on the salinity etc....


just start here;
Matthias explains how to start, then later add extra stuff

http://www.aquariumcomputer.com/Foru...ead.php?t=2342

[diverdan]

thank you very much

[diverdan]

OK, question: I have the optical sensor. The instructions state to set this HORIZONTALLY and have a photo to confirm this. However the picture of the mounting hardware on the GHL Direct site shows that the level sensor is mounted vertically. So who is right? What do you all have?

[Blahenazo]

if you have an optical sensor with a 'black' cone head. Then it needs to be horizontally for sure.
(I have it like that)

[diverdan]

Blahenazo,
How then is it mounted to the proble holder assembly? The mounting bracket is made only for a vertical fit?
Thank you again!
Rich

[Blahenazo]

There is one that makes a 90 degree angle

I believe its this one
PL-LF-S12