PAB Powerbar

[Johan]

Hi

I have problems to install my PAB Powerbars. I have done it by the book and "Operation of PAB".
I have one (1) PAB Group
In "Configure Device" I can see two PAB 1.st ???1005055007 2.nd ???1005055005
In "Assign device" (enter) --> "No devices found!"

Led Pwr is constant Green
Led Com Flash Yelow by 1sec
PAB-cable from GHL3-Powerbar1-Powerbar2 (No ring)

Whats the problem, do I do anything wrong?

/Johan

[Blahenazo]

you have to press the side arrow when you want to assign the devices.

you need to see a checkmark in the squared box. Then it is really assigned.

[Johan]

you have to press the side arrow when you want to assign the devices.

you need to see a checkmark in the squared box. Then it is really assigned.

Nothing happens when I push the arrowbutton. Under "Assign Devices" I can only press "enter".

Checkmarks where?

/Johan

[Matthias]

Hi Johan,

the S/N show me that this is the newest batch of the powerbars.

The firmware 5.00p didn't "know" these powerbars, if you use 5.00p then please update to 5.00q (or higher), this version will work with all powerbar versions.

[Johan]

Hi Johan,

the S/N show me that this is the newest batch of the powerbars.

The firmware 5.00p didn't "know" these powerbars, if you use 5.00p then please update to 5.00q (or higher), this version will work with all powerbar versions.

Hi

I try to update to 5.00q byt now I get "Communication Error 28" when I try to connect via USB instead of LAN. I use the right COM-port.

Can´t find the type och USB-card I have as you say in other links when I open the GHL3 and try to find the text on the card.

What to do?

/Johan

[Matthias]

I don`t know what ProfiLuxControl version you use

please use the newest

[Johan]

I don`t know what ProfiLuxControl version you use

please use the newest

I did download and installed ver 5.0.1.1 and tryed it whit no luck.

/Johan

[GHL Support]

Are you sure you use the correct communication settings?

Interface
Com ##: your numer of your com-port
9600 Baud

Device address: 1 (if not changed on ProfiLux)

Search for SMS module: unchecked
RS485 delay: unchecked

Type of connection: RS232
Timeout: 2000ms

[Johan]

Hi

Setup
Com18
Baud 9600
Device 1 Same as in PL3
Connection USB/RS232
Timeout 5000ms
Search för SMS Unchecked
RS485 Delay Unchecked

/Johan

Are you sure you use the correct communication settings?

Interface
Com ##: your numer of your com-port
9600 Baud

Device address: 1 (if not changed on ProfiLux)

Search for SMS module: unchecked
RS485 delay: unchecked

Type of connection: RS232
Timeout: 2000ms

[Matthias]

some PCs have problems with COM-numbers above 9

-> could you change the COM-number in the windows device manager manually, do the same setting in ProfiLuxControl and try it again?

maybe it helps to enable the RS485 delay - this reduces the transmission speed and may help in some cases