I've changed the description of the probes, socket and 1-10v.
Today I turned off the ProfiLux to organize, when I turned on ProfiLux all descriptions are missing.
Now, there are strange symbols (Ë~Zÿ??ï÷GϪë[ËK)
Why??
Thanks.
I've changed the description of the probes, socket and 1-10v.
Today I turned off the ProfiLux to organize, when I turned on ProfiLux all descriptions are missing.
Now, there are strange symbols (Ë~Zÿ??ï÷GϪë[ËK)
Why??
Thanks.
Did you make a firmware update? Then this could happen.
To prevent this, store the settings with PLC and reload it, if necessary.
On which Firmware version are we talking about?
Hi,
I have the firmware version -> FW-version 5.09 date: 30/05/2011 and I have not updated anything.
Regards
Are profilux description storeded in volatile or non volatile?
they are stored in NON-volatile memory of course
EgaReef, did you change something in the hardware configuration?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
... yes I agree also.
TYPO from me!!!
is correct!they are stored in NON-volatile memory of course
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Well it looks like there is a bug in 5.09, I had set all my name on illumination, probes and socket a few weeks ago. I had to power down the profilux today and when I powered back up I had lost all of my custom text. Every text was replaced by the strange symbols (Ë~Zÿ??ï÷GϪë[ËK) like above.
This is on a P3EX with a Expantion box, adin and temp/humidity card (In P3).
So I set the text again and powercycled to see and infact I am loosing all my texts on powercycle.
Bookmarks