If i got 2 ghl ex3 computers, and i export the settings from one of them, and import it into another, does the probe calibration follow? or should i still recalibrate those? (i am using the same probes)
If i got 2 ghl ex3 computers, and i export the settings from one of them, and import it into another, does the probe calibration follow? or should i still recalibrate those? (i am using the same probes)
I would make sure the profiluxes are on the same FW.
in PLC
- connect to the source profilux.
- File
- save parameter to file
This has all the configs of this profilux.
import on the other profilux.
since not one probe is the same and not even each profilux (therefore you need to calibrate, to 'avoid' these differences)
I think its best to recalibrate on the other profilux.
remark: if you have exbox , extra devices ,... make sure these are already connected.
Last edited by Blahenazo; 25.05.2010 at 18:05.
Hi
Tnx for your reply, u were right, i had to recalibrate tnx though!
Bookmarks